為保證骨料倉能連續下料，保證計量精度，除砂石其余材料（土石灰粉煤等）必需用皮帶上料機上料，不允許用裝載機，汽車或挖掘機等直接上料。嚴格保證各種原材料的顆粒徑及含水量。

To ensure continuous feeding of the aggregate bin and measurement accuracy, materials other than sand and gravel (such as soil, stone, ash, and coal) must be loaded using a belt feeder, and direct loading using loaders, trucks, or excavators is not allowed. Strictly ensure the particle size and moisture content of various raw materials.

有關穩定土拌合機設備的日常保養技巧大家又知道多少呢，下面我們就一起來詳細地看一下：

How much do you know about the daily maintenance skills of stabilized soil mixer equipment? Let's take a detailed look together:

每星期打開一次各傳動鏈條罩殼，并在鏈條上加涂少量的潤滑脂，每工作300小時清洗鏈條一次。

Open each transmission chain cover once a week and apply a small amount of lubricating grease to the chain. Clean the chain every 300 hours of operation.

每班工作結束后，將混合料存?zhèn)}中的物料排放干凈，切斷總電源，打開攪拌器的上蓋，檢查攪拌臂與葉漿的緊固情況，發現螺母松動應立即擰緊，以免葉漿脫落造成事故;清洗或清除設備中各處所粘附的物料，以免物料粘結硬化，影響設備的正常使用。

After each shift, discharge the materials in the mixed material storage bin thoroughly, cut off the main power supply, open the upper cover of the mixer, check the fastening of the mixing arm and the blade slurry, and tighten the nuts immediately if any looseness is found to prevent accidents caused by the blade slurry falling off; Clean or remove materials adhered to various parts of the equipment to prevent material adhesion and hardening, which may affect the normal use of the equipment.

減速機及電動滾筒按使用說明書中的相應條款執行。

The reducer and electric drum shall be executed according to the corresponding terms in the user manual.

攪拌機缸體上的蓋板破損后要及時修復，以免物料飛出傷人。

After the cover plate on the mixer cylinder is damaged, it should be repaired in a timely manner to prevent materials from flying out and injuring people.

攪拌機的傳動齒輪每天開機前應涂抹黃油少許。

The transmission gears of the mixer should be coated with a little butter before starting up every day.

每周清洗各皮帶機和帶式給料機的張緊絲桿一次，并涂上新的潤滑脂。

Clean the tensioning screw of each belt conveyor and belt feeder once a week and apply new lubricating grease.

攪拌器的工作條件惡劣，當葉漿磨損到面積不足原來的2/3時，應更換葉漿。

The working conditions of the agitator are harsh. When the blade slurry is worn to less than 2/3 of the original area, the blade slurry should be replaced.

攪拌器集料皮帶機上料皮帶機各配料機螺旋輸送機的軸承處，每天開機前應用黃油槍向油杯中加注潤滑脂5-8下，每工作200小時拆開檢查，換上新的潤滑脂。

At the bearing of the screw conveyor of each batching machine on the mixer, aggregate conveyor, and feeding conveyor, apply grease gun 5-8 times to the oil cup before starting up every day. Disassemble and inspect every 200 hours of operation, and replace with new grease.

本文來自：濟南水穩攪拌站更多的內容請點擊：http://www.huatts.com我們將會為您提問的問題提供一個滿意的服務，歡迎您的來電！

This article is from Jinan Water Stable Mixing Station. For more information, please click: http://www.huatts.com We will provide satisfactory service for the questions you ask. Welcome to call us!